Dell PowerVault NX200 Hardware Owner's Manual - Page 119
Install the new battery by pressing down firmly on the positive side
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Figure 3-20. Replacing the System Battery 1 2 3 1 positive side of battery connector 3 negative side of battery connector 2 system battery 4 Remove the PCIe expansion card from slot 1. See "Removing an Expansion Card" on page 107. 5 Locate the battery socket. See "System Board Connectors" on page 152. CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery. 6 Support the battery connector by pressing down firmly on the positive side of the connector. 7 Press the battery toward the positive side of the connector and lift it up out of the securing tabs at the negative side of the connector. 8 Install the new battery by pressing down firmly on the positive side of the connector. 9 Hold the battery with the "+" facing up, and slide it under the securing tabs at the positive side of the connector. 10 Press the battery straight down into the connector until it snaps into place. 11 Install the expansion card. See "Installing an Expansion Card" on page 104. 12 Install the expansion card stabilizer. See "Installing the Expansion Card Stabilizer" on page 81. Installing System Components 117