Dell PowerVault NX200 Hardware Owner's Manual - Page 48
Unsupported CPU, System Services
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Table 1-2. System Messages (continued) Message Causes Unable to launch System Services image. System halted! System halted after F10 keystroke because System Services image is either corrupted in the system firmware or has been lost due to system board replacement. Unexpected interrupt in protected mode Improperly seated memory modules or faulty keyboard/mouse controller chip. Unsupported CPU combination Unsupported CPU stepping detected Unsupported DIMM detected. The following DIMM has been disabled: x Processor is not supported by the system. Invalid memory configuration. The system will run but with the specified memory module disabled. Unsupported memory configuration. DIMM mismatch across slots detected: x,x,... Invalid memory configuration. Memory modules are mismatched in the specified slots. Corrective Actions Restart the system and update the Unified Server Configurator repository to the latest software to restore full functionality. See the Unified Server Configurator user documentation for more information. Reseat the memory modules. See "Troubleshooting System Memory" on page 137. If the problem persists, see "Getting Help" on page 157. Install a supported processor. See "Processor" on page 112. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 98. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 98. 48 About Your System