Dell PowerVault NX200 Hardware Owner's Manual - Page 129
Card on Connect all the cables to the system board.
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
5 Slide the system board toward the back of the system, inserting the connectors into the cutouts in the chassis. 6 Using a Phillips screwdriver, tighten the screws. 7 If applicable, replace the SATA backplane. See "Installing the SATA Backplane" on page 124. 8 Replace the heat sink and processor. See "Installing a Processor" on page 115. 9 Replace the system fan. See "Installing the System Fan" on page 97. 10 Replace all the memory modules and memory blanks. See "Installing Memory Modules" on page 100. 11 If applicable, replace the iDRAC6 Express card. See "Installing an iDRAC6 Express Card" on page 108. 12 If applicable, replace all the expansion cards. See "Installing an Expansion Card" on page 104. 13 Connect all the cables to the system board. 14 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 83. 15 Replace the expansion card stabilizer. See "Installing the Expansion Card Stabilizer" on page 81. 16 Close the system. See "Closing the System" on page 80. 17 Place the system upright on a flat surface. 18 Reattach any peripherals and connect the system to an electrical outlet. 19 Turn on the system and attached peripherals. NOTE: See "Running the System Diagnostics" on page 147 to verify that the new processor operates correctly. See "Running the Embedded System Diagnostics" on page 148 for information about running the diagnostics. Installing System Components 127