Dell PowerVault NX200 Hardware Owner's Manual - Page 95
the chassis and slide the drive into the drive bay until the shoulder screws
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
6 Attach the three shoulder screws to the drive, one screw on the lower front screw hole on the right side and two screws on the lower screw holes on the left side. See Figure 3-11. NOTE: If the optical drive you are installing does not have shoulder screws, remove the three shoulder screws from the old drive or the back of the 5.25inch front bezel insert. Figure 3-11. Installing Optical Drive Shoulder Screws 1 1 shoulder screws (3) 7 From the front of the system, align the shoulder screws with the slots in the chassis and slide the drive into the drive bay until the shoulder screws snap into place. See Figure 3-10. 8 Attach the power and data cables to the drive. 9 Replace the front bezel. See "Installing the Front Bezel" on page 76. 10 Close the system. See "Closing the System" on page 80. Installing System Components 93