Dell PowerVault NX200 Hardware Owner's Manual - Page 85
Installing the Cooling Shroud, Removing and Installing the Cooling Shroud
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Figure 3-6. Removing and Installing the Cooling Shroud 1 5 4 2 3 1 cooling shroud 3 expansion card stabilizer touch points (2) 5 cooling shroud touch point 2 expansion card stabilizer 4 cable bracket Installing the Cooling Shroud 1 Carefully lower the cooling shroud into the system holding by the touch point. 2 Ensure that no cables are pinned under the edges of the cooling shroud. 3 Secure the cable into the bracket on the side of the cooling shroud. 4 Replace the expansion card stabilizer. See "Installing the Expansion Card Stabilizer" on page 81. 5 Close the system. See "Closing the System" on page 80. Installing System Components 83
Installing System Components
83
Figure 3-6.
Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1
Carefully lower the cooling shroud into the system holding by the
touch point.
2
Ensure that no cables are pinned under the edges of the cooling shroud.
3
Secure the cable into the bracket on the side of the cooling shroud.
4
Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer" on page 81.
5
Close the system. See "Closing the System" on page 80.
1
cooling shroud
2
expansion card stabilizer
3
expansion card stabilizer touch
points (2)
4
cable bracket
5
cooling shroud touch point
1
2
3
5
4