Dell PowerVault NX200 Hardware Owner's Manual - Page 98
System Fan, Removing the System Fan
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
5 Place the system upright on a flat surface. 6 Reattach any peripherals and connect the system to an electrical outlet. 7 Turn on the system and attached peripherals. System Fan Removing the System Fan WARNING: The system fan can continue to spin for some time after the system has been powered down. Allow time for the fan to stop spinning before removing it from the system. WARNING: Do not attempt to operate the system without the system fan. CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 79. 3 Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer" on page 81. 4 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 82. 5 Disconnect the system fan power cable from the system board. See Figure 3-13. 6 Press the fan release tab and slide the fan out of the securing slots on the chassis. See Figure 3-13. 96 Installing System Components