Dell PowerVault NX200 Hardware Owner's Manual - Page 121
Installing the Chassis Intrusion Switch, See
View all Dell PowerVault NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Figure 3-21. Removing and Installing the Chassis Intrusion Switch 1 2 3 1 chassis intrusion switch 3 intrusion connector on the system board 2 chassis intrusion switch cable Installing the Chassis Intrusion Switch 1 Align the chassis intrusion switch with the securing bracket notch. See Figure 3-21. 2 Slide the switch into the securing bracket notch. See Figure 3-21. 3 Connect the chassis intrusion switch cable to the connector on the system board. 4 Close the system. See "Closing the System" on page 80. 5 Place the system upright on a flat surface. 6 Reattach any peripherals and connect the system to an electrical outlet. 7 Turn on the system and attached peripherals. Installing System Components 119
Installing System Components
119
Figure 3-21.
Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1
Align the chassis intrusion switch with the securing bracket notch.
See Figure 3-21.
2
Slide the switch into the securing bracket notch. See Figure 3-21.
3
Connect the chassis intrusion switch cable to the connector on
the system board.
4
Close the system. See "Closing the System" on page 80.
5
Place the system upright on a flat surface.
6
Reattach any peripherals and connect the system to an electrical outlet.
7
Turn on the system and attached peripherals.
1
chassis intrusion switch
2
chassis intrusion switch cable
3
intrusion connector on the
system board
1
2
3