Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 1108

Neighbor ID Pri State 63.114.8.36 1 FULL/DR DellEMC# Dead Time Interface 00:00:38 4 ID Interface Gi 1/2 snmp context Configure SNMPv3 context name to map multiple OSPFv3 VRF instances. Syntax snmp context {context-name} To clear snmp context, use the no snmp context {context-name} command. Parameters context-name Enter the SNMP context name. The maximum length is 32 alphanumeric characters. Defaults None. Command Modes IPv6 ROUTER OSPF Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.14(1.0) Introduced on the S3100 series, S3048-ON, S4048-ON, S4048T-ON, S5048F-ON, S6000, S6010-ON, S6100-ON, Z9100-ON, Z9500, S6000-ON, C9010, MXL, and FN IOM. Usage Information Use SNMPv3 context configuration to distinguish between various OSPFv3 VRF instances. Example DellEMC(conf-ipv6-router_ospf)#snmp context ospf1 DellEMC>show runnig-config ospf ! ipv6 router ospf 10 router-id 10.10.10.1 snmp context ospf1 ! DellEMC> timers spf Set the time interval between when the switch receives a topology change and starts a shortest path first (SPF) calculation. Syntax Parameters timers spf delay holdtime msec To return to the default, use the no timers spf command. delay Enter a number as the delay. The range is from 0 to 2147483647. The default is 5 seconds. When configured in milli seconds, 100 is the least value that is allowed to be configured. holdtime msec Enter a number as the hold time. The range is from 0 to 2147483647. The default is 10 seconds. When configured in milli seconds, 200 is the least value that is allowed to be configured. Enter the keyword msec to specify the time interval value in milli seconds. NOTE: If you do not specify the msec option, the timer values are considered as seconds. 1108 Open Shortest Path First (OSPFv2 and OSPFv3)