Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 679

espauthentication esp-encryption • sha1 - Use Secure Hash Algorithm 1 (SHA-1) authentication. • null - Causes an encryption policy configured for the area to not be inherited on the interface. Enter the keywords esp-authentication then the transform type of operation to apply to traffic. The transform type represents the encryption or authentication applied to traffic. • md5 - Use Message Digest 5 (MD5) authentication. • sha1 - Use Secure Hash Algorithm 1 (SHA-1) authentication. • null - Causes an encryption policy configured for the area to not be inherited on the interface. Enter the keywords esp-encryption then the transform type of operation to apply to traffic. The transform type represents the encryption or authentication applied to traffic. • 3des - Use 3DES encryption. • cbc - Use CDC encryption. • des - Use DES encryption. • null - Causes an encryption policy configured for the area to not be inherited on the interface. Defaults None Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(0.2) 9.2(1.0) Introduced on the S3148. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9000, S4810, and S4820T. Introduced on the Z9500. Usage Information • Both sides of the link must specify the same transform set. • You can create up to 64 transform sets. Example Dell(conf)# do show crypto ipsec transform-set Transform-Set Name Transform-Set refCnt AH Transform ESP Auth Transform ESP Encry Transform : ts1 : 0 : md5 : : Dell(conf)# crypto ipsec policy Create a crypto policy used by ipsec. Syntax crypto ipsec policy name seq-num ipsec-manual To delete a crypto policy entry, use the no crypto ipsec policy name seq-num ipsec-manual command. Internet Protocol Security (IPSec) 679