Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 600

errdisable recovery interval Configure recovery time interval to move an interface from the Err-disabled state. Syntax errdisable recovery interval seconds To remove the configured recovery time interval, use the no errdisable recovery interval seconds command. Parameters interval seconds Enter the keyword interval and the number of seconds to recover the interface from Err-disabled state. The range is from 30 to 86,400 seconds. The default is 300 seconds. Defaults 300 seconds. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.14(0.0) 9.13(0.2P2) Introduced on the platforms S4048-ON, S6100-ON, Z9100-ON, S4048T-ON, S3048- ON, S6000, S6010-ON, S5048F-ON, FN-IOM, and MXL. Introduced on the S3100. Usage Information Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer expires. Following message is displayed after each Err-disable recovery timer configuration: DellEMC(conf)# errdisable recovery interval 30 New timer interval will be effective from the next timer instance only. Related Commands errdisable recovery cause - Enable automatic recovery of an interface from the error disabled state. flowcontrol Control how the system responds to and generates 802.3x pause flow control frames. Syntax flowcontrol {rx {off | on} tx {off | on} [negotiate | pause-threshold value | resume-offset value] | [monitor session-ID]} To return to the default, use the no form of this command. Parameters rx on Enter the keywords rx on to process the received flow control frames on this port. NOTE: Flow-control packets are mirrored only when flow-control rx is enabled on an interface. rx off tx on tx off pause-threshold resume-offset negotiate monitor Enter the keywords rx off to ignore the received flow control frames on this port. Enter the keywords tx on to send control frames from this port to the connected device when a higher rate of traffic is received. Enter the keywords tx off so that flow control frames are not sent from this port to the connected device when a higher rate of traffic is received. Enter the buffer threshold limit for generating PAUSE frames. Enter the offset value for generating PAUSE frames to resume traffic. (Optional) Enter the keyword negotiate to enable the pause-negotiation with the egress port of the peer device. If the negotiate command is not used, pausenegotiation is disabled. 40-gigabit Ethernet interfaces do not support pause-negotiation Enter the keyword monitor then the session-ID to enable mirror flow control frames on the interface. The range is from 0 to 65535. 600 Interfaces