Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 622

Example Example Example (Vlan) NOTE: Remove all other configurations on the port before you can remove the hybrid configuration from the port. DellEMC(conf)# interface gigabitethernet 1/1 DellEMC(conf-if-gi-1/1)# portmode hybrid DellEMC(conf-if-gi-1/1)# interface vlan 10 DellEMC(conf-if-vl-10)# untagged gigabitethernet 1/1 DellEMC(conf-if-vl-10)# interface vlan 20 DellEMC(conf-if-vl-20)# tagged gigabitethernet 1/1 DellEMC(conf-if-vl-20)# DellEMC(conf-if-vl-20)# do show interfaces switchport Name: GigabitEthernet 1/1 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 DellEMC(conf-if-vl-20)# DellEMC(conf-if-vl-20)# interface vlan 10 DellEMC(conf-if-vl-10)# no untagged gigabitethernet 1/1 DellEMC(conf-if-vl-10)# interface vlan 20 DellEMC(conf-if-vl-20)# no tagged gigabitethernet 1/1 DellEMC(conf-if-vl-20)# interface gigabitethernet 1/1 DellEMC(conf-if-gi-1/1)# no portmode hybrid DellEMC(conf-if-vl-20)# rate-interval Configure the traffic sampling interval on the selected interface. Syntax Parameters rate-interval seconds seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299 seconds. NOTE: Because polling occurs every 15 seconds, the number of seconds designated here rounds to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59 seconds rounds to 45. Defaults 299 seconds Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. 622 Interfaces