Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 1576

Version 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 E-Series original Command Description Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the C-Series and S-Series. Usage Information Prior to disabling the stackable VLAN feature, remove the members. To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable VLANs contain members, designated by the M in the Q column of the command output. If you enabled VRF, you cannot enable the stacked VLAN feature using this command. If you enabled IGMP snooping, you cannot enable the stacked VLAN feature using this command. Example DellEMC# show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM Status * 1 Inactive 2 Active 3 Active 4 Active 5 Active DellEMC# Q Ports M Gi 1/13 M Gi 1/1-3 M Po1(Gi 1/14-15) M Gi 1/18 M Gi 1/4 M Po1(Gi 1/14-15) M Gi 1/18 M Gi 1/5 M Po1(Gi 1/14-15) M Gi 1/18 M Gi 1/6 vlan-stack dot1p-mapping Map C-Tag dot1p values to an S-Tag dot1p value. Syntax Parameters vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p value that is mapped to a service provider do1p value. The range is from 0 to 7. sp-tag-dot1p value Enter the keyword sp-tag-dot1p then the service provider dot1p value. The range is from 0 to 7. Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. 1576 VLAN Stacking