Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 48

When you are in EXEC mode, the > prompt is displayed following the host name prompt, which is "DellEMC" by default. You can change the host name prompt using the hostname command. NOTE: Each mode prompt is preceded by the host name. EXEC Privilege Mode The enable command accesses EXEC Privilege mode. If an administrator has configured an "Enable" password, you are prompted to enter it. EXEC Privilege mode allows you to access all the commands accessible in EXEC mode, plus other commands, such as to clear address resolution protocol (ARP) entries and IP addresses. In addition, you can access CONFIGURATION mode to configure interfaces, routes and protocols on the switch. While you are logged in to EXEC Privilege mode, the # prompt is displayed. EXTENDED COMMUNITY LIST Mode To enable and configure a BGP extended community, use EXTENDED COMMUNITY LIST mode. To enter EXTENDED COMMUNITY LIST mode: 1. Verify that you are logged in to CONFIGURATION mode. 2. Enter the ip extcommunity-list command then a community list name. The prompt changes to include conf-ext- community-list. You can return to CONFIGURATION mode by using the exit command. FRRP Mode To enable or configure Force10 Resilient Ring Protocol (FRRP), use FRRP mode. For more information, see Force10 Resilient Ring Protocol (FRRP). To enter FRRP mode: 1. Verify that you are logged in to CONFIGURATION mode. 2. Enter the protocol frrp command then the ring ID. The prompt changes to include conf-frrp-ring-id. You can return to CONFIGURATION mode by using the exit command. INTERFACE Mode Use INTERFACE mode to configure interfaces or IP services on those interfaces. An interface can be physical (for example, a Gigabit Ethernet port) or virtual (for example, the Null interface). To enter INTERFACE mode: 1. Verify that you are logged in to CONFIGURATION mode. 2. Enter the interface command and then enter an interface type and interface number that is available on the switch. NOTE: In Dell EMC Networking OS, the stack unit number and interfaces start from 0. But in Dell EMC Networking OS Open Networking platforms, the stack unit number and interfaces start from 1. The prompt changes to include the designated interface and slot/port number. For example: Prompt Interface Type DellEMC(confif)# DellEMC(confif-gi-1/1)# DellEMC(confif-te-1/1)# DellEMC(confif-lo-0)# INTERFACE mode Gigabit Ethernet interface then the slot/port information Ten-Gigabit Ethernet interface then slot/port information Loopback interface number 48 CLI Basics