Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 598

• Spaces between characters are not preserved after entering this command unless you enclose the entire description in quotation marks ("desc_text"). • Entering a text string after the description command overwrites any previous text string that you previously configured as the description. • The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port-channel. • Use the show interfaces description command to display descriptions configured for each interface. eee Enable Energy-Efficient Ethernet (EEE) on native or optional module copper ports. Syntax eee To disable EEE, use the no eee command. Defaults None. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.11(0.) 9.10(0.1) 9.10(0.0) Introduced on the S3048-ON. Introduced on the S4820T and S5000. Introduced on the S3100 series. Usage Information EEE is an IEEE 802.3 az standard that reduces power consumptions on Ethernet ports. When EEE is enabled, transmission is stopped when there is no data to be transmitted and is resumed on arrival of new packets. You can enable EEE only on one Gigabit and ten Gigabit native or optional module copper ports. Example To enable EEE: DellEMC(conf)# interface gigabitethernet 1/1 DellEMC(conf-if-gi-1/1)# eee To disable EEE: DellEMC(conf)# interface gigabitethernet 1/1 DellEMC(conf-if-gi-1/1)# no eee encapsulation dot1q Configures lite-subinterfaces. Syntax encapsulation dot1q vlan-id To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id command. Parameters dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The range is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property and is synchronous with the existing rules of applying Layer 2 or Layer 3 properties to an interface. Command Modes INTERFACE 598 Interfaces