Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.5 - Page 1110

39 Policy-based Routing (PBR) Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR, create a redirect list and apply it to the interface. After the redirect list is applied to the interface, all traffic passing through the interface is subject to the rules defined in the redirect list. PBR is supported by the Dell EMC Networking OS. You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network [VLAN]). Trace lists and redirect lists do not function correctly when you configure both in the same configuration. NOTE: Apply PBR to Layer 3 interfaces only. NOTE: For more information , see Content Addressable Memory (CAM). Topics: • description • ip redirect-group • ip redirect-list • permit • redirect • seq • show cam pbr • show ip redirect-list description Add a description to this redirect list. Syntax Parameters description {description} To remove the description, use the no description {description} command. description Enter a description to identify the IP redirect list (16 characters maximum). Defaults None Command Modes REDIRECT-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. 1110 Policy-based Routing (PBR)