Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 104

www.dell.com | support.dell.com To delete a filter, enter the show config command in the PREFIX LIST mode and locate the sequence number of the filter you want to delete; then use the no seq sequence-number command in the PREFIX LIST mode. To view all configured prefix lists, use either of the following commands in the EXEC mode: Command Syntax show ip prefix-list detail [prefix-name] show ip prefix-list summary [prefix-name] Command Mode EXEC Privilege EXEC Privilege Purpose Show detailed information about configured Prefix lists. Show a table of summarized information about configured Prefix lists. Figure 6-13. Command example: show ip prefix-list detail FTOS>show ip prefix detail Prefix-list with the last deletion/insertion: filter_ospf ip prefix-list filter_in: count: 3, range entries: 3, sequences: 5 - 10 seq 5 deny 1.102.0.0/16 le 32 (hit count: 0) seq 6 deny 2.1.0.0/16 ge 23 (hit count: 0) seq 10 permit 0.0.0.0/0 le 32 (hit count: 0) ip prefix-list filter_ospf: count: 4, range entries: 1, sequences: 5 - 10 seq 5 deny 100.100.1.0/24 (hit count: 0) seq 6 deny 200.200.1.0/24 (hit count: 0) seq 7 deny 200.200.2.0/24 (hit count: 0) seq 10 permit 0.0.0.0/0 le 32 (hit count: 0) FTOS> Figure 6-14. Command Example: show ip prefix-list summary FTOS>show ip prefix summary Prefix-list with the last deletion/insertion: filter_ospf ip prefix-list filter_in: count: 3, range entries: 3, sequences: 5 - 10 ip prefix-list filter_ospf: count: 4, range entries: 1, sequences: 5 - 10 FTOS> Use a prefix list for route redistribution To pass traffic through a configured prefix list, you must use the prefix list in a route redistribution command. The prefix list is applied to all traffic redistributed into the routing process and the traffic is either forwarded or dropped depending on the criteria and actions specified in the prefix list. 82 | Access Control Lists (ACLs)