Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 806

www.dell.com | support.dell.com Table 44-4. Copying Configuration Files via SNMP (continued) Task Figure 44-11. Copying Configuration Files via SNMP and TFTP to a Remote Server .snmpset -v 2c -c private -m ./f10-copy-config.mib 10.10.10.10 copySrcFileType.4 i 3 copyDestFileType.4 i 1 copyDestFileLocation.4 i 3 copyDestFileName.4 s /home/myfilename Copy a binary file from the server to the startup-configuration on the Dell Networking system via FTP using the following command from the Unix server: snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address copySrcFileType.index i 1 copySrcFileLocation.index i 4 copySrcFileName.index s filepath/filename copyDestFileType.index i 3 copyServerAddress.index a server-ip-address copyUserName.index s server-login-id copyUserPassword.index s server-login-password Figure 44-12. Copying Configuration Files via SNMP and FTP from a Remote Server > snmpset -v 2c -c private -m ./f10-copy-config.mib 10.10.10.10 copySrcFileType.10 i 1 copySrcFileLocation.10 i 4 copyDestFileType.10 i 3 copySrcFileName.10 s /home/myfilename copyServerAddress.10 a 172.16.1.56 copyUserName.10 s mylogin copyUserPassword.10 s mypass Dell Networking provides additional MIB Objects to view copy statistics. These are provided in Table 44-5. Table 44-5. MIB Objects for Copying Configuration Files via SNMP MIB Object copyState OID .1.3.6.1.4.1.6027.3.5.1.1.1.11 copyTimeStarted .1.3.6.1.4.1.6027.3.5.1.1.1.12 copyTimeCompleted .1.3.6.1.4.1.6027.3.5.1.1.1.13 copyFailCause .1.3.6.1.4.1.6027.3.5.1.1.1.14 copyEntryRowStatus .1.3.6.1.4.1.6027.3.5.1.1.1.15 Values Description 1= running 2 = successful 3 = failed Specifies the state of the copy operation. Time value Specifies the point in the up-time clock that the copy operation started. Time value Specifies the point in the up-time clock that the copy operation completed. 1 = bad file name Specifies the reason the copy request 2 = copy in progress failed. 3 = disk full 4 = file exists 5 = file not found 6 = timeout 7 = unknown Row status Specifies the state of the copy operation. Uses CreateAndGo when you are performing the copy. The state is set to active when the copy is completed. 784 | Simple Network Management Protocol (SNMP)