Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 707

Configuration Task List for RIP • Enable RIP globally on page 685 (mandatory) • Configure RIP on interfaces on page 686 (optional) • Control RIP routing updates on page 687 (optional) • Set send and receive version on page 688 (optional) • Generate a default route on page 690 (optional) • Control route metrics on page 691 (optional) • Summarize routes on page 690 (optional) • Control route metrics on page 691 • Debug RIP on page 691 For a complete listing of all commands related to RIP, refer to the FTOS Command Line Reference. Enable RIP globally By default, RIP is not enabled in FTOS. To enable RIP, use the following commands in sequence, starting in the CONFIGURATION mode: Step 1 Command Syntax router rip 2 network ip-address Command Mode CONFIGURATION ROUTER RIP Purpose Enter ROUTER RIP mode and enable the RIP process on FTOS. Assign an IP network address as a RIP network to exchange routing information. You can use this command multiple times to exchange RIP information with as many RIP networks as you want. After designating networks with which the system is to exchange RIP information, ensure that all devices on that network are configured to exchange RIP information. The FTOS default is to send RIPv1, and to receive RIPv1 and RIPv2. To change the RIP version globally, use the version command in the ROUTER RIP mode. When RIP is enabled, you can view the global RIP configuration by using the show running-config command in the EXEC mode or the show config command in the ROUTER RIP mode as shown in the following example. Figure 38-1. show config Command Example in ROUTER RIP mode FTOS(conf-router_rip)#show config ! router rip network 10.0.0.0 FTOS(conf-router_rip)# Routing Information Protocol (RIP) | 685