Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 814

www.dell.com | support.dell.com Figure 44-24. Display the Interface Index Number FTOS#show interface te 1/21 TenGigabitEthernet 1/21 is up, line protocol is up Hardware is Force10Eth, address is 00:01:e8:0d:b7:4e Current address is 00:01:e8:0d:b7:4e Interface index is 72925242 [output omitted] FTOS#show stack-unit all | grep 1 The interface index is a binary number with bits that indicate the slot number, port number, interface type, and card type of the interface. FTOS converts this binary index number to decimal, and displays it in the output of the show interface command. Figure 44-25. Interface Index Binary Calculations 1 bit 1 bit 5 bits 7 bits 4 bits 14 bits Unused P/L Flag Slot Number Port Number Interface Type Card Type Starting from the least significant bit (LSB): • the first 14 bits represent the card type • the next 4 bits represent the interface type • the next 7 bits represent the port number • the next 5 bits represent the slot number • the next 1 bit is 0 for a physical interface and 1 for a logical interface • the next 1 bit is unused For example, the index 72925242 is 100010110001100000000111010 in binary. The binary interface index for TenGigabitEthernet 1/21 of a 48-port 10/100/1000Base-T line card with RJ-45 interface is shown in Figure 44-26. Notice that the physical/logical bit and the final, unused bit are not given. The interface is physical, so this must be represented by a 0 bit, and the unused bit is always 0. These two bits are not given because they are the most significant bits, and leading zeros are often omitted. Figure 44-26. Binary Representation of Interface Index 2 bits 7 bits 10 0010110 Slot Port Number Number 4 bits 14 bits 0011 00000000111010 Interface Card Type Type 792 | Simple Network Management Protocol (SNMP)