Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 633

Command Syntax ip ospf hello-interval seconds ip ospf message-digest-key keyid md5 key ip ospf priority number ip ospf retransmit-interval seconds ip ospf transmit-delay seconds Command Mode Usage CONFIG-INTERFACE Change the time interval between hello-packet transmission. Seconds range: from 1 to 65535 (default is 10 seconds). The hello interval must be the same on all routers in the OSPF network. CONFIG-INTERFACE Use the MD5 algorithm to produce a message digest or key, which is sent instead of the key. Keyid range: 1 to 255 Key: a character string Be sure to write down or otherwise record the Key. You cannot learn the key once it is configured. You must be careful when changing this key. CONFIG-INTERFACE Change the priority of the interface, which is used to determine the Designated Router for the OSPF broadcast network. Number range: 0 to 255 (the default is 1). CONFIG-INTERFACE Change the retransmission interval between LSAs. Seconds range: from 1 to 65535 (default is 5 seconds). The retransmit interval must be the same on all routers in the OSPF network. CONFIG-INTERFACE Change the wait period between link state update packets sent out the interface. Seconds range: from 1 to 65535 (default is 1 second). The transmit delay must be the same on all routers in the OSPF network. Use the show config command in CONFIGURATION INTERFACE mode (Figure 31-16) to view interface configurations. Use the show ip ospf interface command in EXEC mode to view interface status in the OSPF process. Open Shortest Path First (OSPFv2) | 611