Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 509

To configure the LACP long timeout (Figure 196): Step 1 Task Set the LACP timeout value to 30 seconds. Command Syntax lacp long-timeout Command Mode CONFIG-INT-PO Figure 25-4. Invoking the LACP Long Timeout FTOS(conf)# interface port-channel 32 FTOS(conf-if-po-32)#no shutdown FTOS(conf-if-po-32)#switchport FTOS(conf-if-po-32)#lacp long-timeout FTOS(conf-if-po-32)#end FTOS# show lacp 32 Port-channel 32 admin up, oper up, mode lacp Actor System ID: Priority 32768, Address 0001.e800.a12b Partner System ID: Priority 32768, Address 0001.e801.45a5 Actor Admin Key 1, Oper Key 1, Partner Oper Key 1 LACP LAG 1 is an aggregatable link A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state, P - Receiver is not in expired state Port Te 10/6 is enabled, LACP is enabled and mode is lacp Actor Admin: State ADEHJLMP Key 1 Priority 128 Note: View PDU exchanges and the timeout value using the command debug lacp. Refer to Monitor and Debugging LACP on page 487. Monitor and Debugging LACP The system log (syslog) records faulty LACP actions. To debug LACP, use the following command: Command Syntax [no] debug lacp [config | events | pdu [in | out | [interface [in | out]]]] Command Mode EXEC Purpose Debug LACP, including configuration and events. Shared LAG State Tracking Shared LAG State Tracking provides the flexibility to bring down a port channel (LAG) based on the operational state of another LAG. At any time, only two LAGs can be a part of a group such that the fate (status) of one LAG depends on the other LAG. Link Aggregation Control Protocol (LACP) | 487