Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 897

Create a Virtual Router To enable VRRP, you must create a Virtual Router. In FTOS, a VRRP Group is identified by the Virtual Router Identifier (VRID). To enable a Virtual Router, use the following command in the INTERFACE mode. To delete a VRRP group, use the no vrrp-group vrid command in the INTERFACE mode. Task Command Syntax Command Mode Create a virtual router for that interface vrrp-group vrid with a VRID. VRID Range: 1-255 INTERFACE Note: The interface must already have a Primary IP Address defined, and be enabled. Figure 51-2. Command Example: vrrp-group FTOS(conf)#int te 1/1 FTOS(conf-if-te-1/1)#vrrp-group 111 FTOS(conf-if-te-1/1-vrid-111)# Virtual Router ID and VRRP Group identifier Figure 51-3. Command Example Display: show config for the Interface FTOS(conf-if-te-1/1)#show conf ! interface TengigabitEthernet 1/1 ip address 10.10.10.1/24 ! vrrp-group 111 no shutdown FTOS(conf-if-te-1/1)# Note that the interface has an IP Address and is enabled Assign Virtual IP addresses Virtual routers contain virtual IP addresses configured for that VRRP Group (VRID). A VRRP group does not transmit VRRP packets until you assign the Virtual IP address to the VRRP group. S-Series supports a total of 120 VRRP groups on a switch with FTOS or a total of 20 VRRP groups when using SFTOS. The S-Series supports varying number of maximum VRRP groups per interface (Table 51-1). To activate a VRRP Group on an interface (so that VRRP group starts transmitting VRRP packets), configure at least one Virtual IP address in a VRRP group. The Virtual IP address is the IP address of the Virtual Router and does not require the IP address mask. You can configure up to 12 Virtual IP addresses on a single VRRP Group (VRID). Virtual Router Redundancy Protocol (VRRP) | 875