Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 534

www.dell.com | support.dell.com To disable FEFD protocol on one interface, enter the command fefd disable in INTERFACE mode. Disabling an interface will shut down all protocols working on that interface's connected line, and will not delete your previous FEFD configuration which can be enabled again at any time. Step 1 2 3 Task Setup two or more connected interfaces for Layer 2 or Layer 3 use Activate the necessary ports administratively Enable FEFD on each interface Command Syntax ip address ip address, switchport no shutdown fefd {disable | interval | mode} Command Mode INTERFACE INTERFACE INTERFACE Figure 26-7. FEFD enabled interface configuration FTOS(conf-if-gi-1/0)#show config ! interface GigabitEthernet 1/0 no ip address switchport fefd mode normal no shutdown FTOS(conf-if-gi-1/0)#do show fefd | grep 1/0 Gi 1/0 Normal 3 Unknown Debugging FEFD By entering the command debug fefd events in EXEC privilege mode, output is displayed whenever events occur that initiate or disrupt an FEFD enabled connection. Figure 26-8. Debug FEFD events display FTOS#debug fefd events FTOS#config FTOS(conf)#int gi 1/0 FTOS(conf-if-gi-1/0)#shutdown 2w1d22h: %RPM0-P:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down: Gi 1/0 FTOS(conf-if-gi-1/0)#2w1d22h : FEFD state on Gi 1/0 changed from ANY to Unknown 2w1d22h: %RPM0-P:CP %IFMGR-5-OSTATE_DN: Changed interface state to down: Gi 1/0 2w1d22h: %RPM0-P:CP %IFMGR-5-OSTATE_DN: Changed interface state to down: Gi 4/0 2w1d22h: %RPM0-P:CP %IFMGR-5-INACTIVE: Changed Vlan interface state to inactive: Vl 1 2w1d22h : FEFD state on Gi 4/0 changed from Bi-directional to Unknown Entering the command debug fefd packets in EXEC privilege mode will provide output for each packet transmission over the FEFD enabled connection. 512 | Layer 2