Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 276

www.dell.com | support.dell.com Table 13-1. SNMP Traps and OIDs OID String OID Name Receiving power .1.3.6.1.4.1.6027.3.10.1.2.5.1.6 chSysPortXfpRecvPower Transmitting power .1.3.6.1.4.1.6027.3.10.1.2.5.1.8 chSysPortXfpTxPower Temperature .1.3.6.1.4.1.6027.3.10.1.2.5.1.7 chSysPortXfpRecvTemp Description OID to display the receiving power of the connected optics. OID to display the transmitting power of the connected optics. OID to display the Temperature of the connected optics. Note: These OIDs only generate if you enable the enable optic-info-update-interval is enabled. Recognize an Overtemperature Condition An overtemperature condition occurs, for one of two reasons: • The card is too hot. • A sensor has malfunctioned. To discover the cause, inspect cards adjacent to the card reporting the condition. • If directly adjacent cards are not normal temperature, suspect a genuine overheating condition. • If directly adjacent cards are normal temperature, suspect a faulty sensor. When the system detects a genuine over-temperature condition, it powers off the card. To recognize this condition, look for the system messages shown in Message 3. Message 3 Over Temperature Condition System Messages CHMGR-2-MAJOR_TEMP: Major alarm: chassis temperature high (temperature reaches or exceeds threshold of [value]C) CHMGR-0-TEMP_SHUTDOWN_WARN: Unit 0 temperature exceeded or equal to shutdown temperature 85C; Unit will shutdown now. To view the programmed alarm thresholds levels, including the shutdown value, use the show alarms threshold command, shown in the following output example. 254 | Debugging and Diagnostics