Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 638

www.dell.com | support.dell.com Use the following command in EXEC Privilege mode to view the OSPFv2 configuration for LSA throttling: Command Syntax show ip ospf timers rate-limit Command Mode Usage EXEC Privilege View the LSAs currently in the queue. Use the following command in EXEC Privilege mode to configure the debugging options of an OSPFv2 process: Command Syntax Command Mode Usage debug ip ospf process-id [event | packet | spf | database-timers rate-limit] EXEC Privilege View debug messages. To view debug messages for a specific OSPF process ID, enter debug ip ospf process-id. If you do not enter a process ID, the command applies to the first OSPF process. To view debug messages for a specific operation, enter one of the optional keywords: • event: view OSPF event messages • packet: view OSPF packet information. • spf: view shortest path first (spf) information. • database-timers rate-limit: view the LSAs currently in the queue Sample Configurations for OSPFv2 The following configurations are examples for enabling OSPFv2. These are not comprehensive directions. They are intended to give you a some guidance with typical configurations. You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to support your own IP Addresses, Interfaces, Names, etc. Basic OSPFv2 Router Topology The following illustration is a sample basic OSPFv2 topology. Figure 31-19. Basic topology and CLI commands for OSPFv2 616 | Open Shortest Path First (OSPFv2)