Dell S6000 FTOS 9.0(2.0) Configuration Guide for the System - Page 61

Configure FTP client parameters To configure FTP client parameters, use the following commands in the CONFIGURATION mode: Command Syntax ip ftp source-interface interface ip ftp password password ip ftp username name Command Mode CONFIGURATION CONFIGURATION CONFIGURATION Purpose Enter the following keywords and slot/port number information: • For a 1- Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a loopback interface, enter the keyword loopback followed by a number between 0 and 16383. • For a port channel interface, enter the keyword port-channel followed by a number from 1 to 255 for TeraScale and ExaScale. • For a 10-Tengigabit Ethernet interface, enter the keyword TengigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Tengigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Configure a password. Enter username to use on FTP client. To view FTP configuration, use the show running-config ftp Command Output in the EXEC privilege mode. Terminal Lines You can access the system remotely and restrict access to the system by creating user profiles. The terminal lines on the system provide different means of accessing the system. The console line (console) connects you through the Console port in the RPMs. The virtual terminal lines (VTY) connect you through Telnet to the system. The auxiliary line (aux) connects secondary devices such as modems. Deny and Permit Access to a Terminal Line Dell Networking recommends applying only standard ACLs to deny and permit access to VTY lines. • Layer 3 ACL deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny any traffic. • You cannot use show ip accounting access-list to display the contents of an ACL that is applied only to a VTY line. Management | 39