Denon D-F100MC Owners Manual - Page 9
REMOTE CONTROL UNIT, The DRA-F100 comes with a system remote control unit RC-829.
View all Denon D-F100MC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
6 REMOTE CONTROL UNIT The DRA-F100 comes with a system remote control unit (RC-829). Inserting the batteries NOTES: • Use R6P (AA) batteries in this remote control unit. • Replace the batteries with new ones approximately once each year, though this depends on how frequently the remote control unit is used. • Replace the batteries with new ones earlier if the remote control unit does not operate even from a short distance. • Insert the batteries in the proper + and - direction, following the marks in the battery compartment. • Remove the batteries when not using the remote control unit for extended periods of time. • To avoid damage and leakage: • Do not use a new battery with an old one. • Do not use two different types of batteries. • Do not short-circuit, take apart, heat or dispose of batteries in flames. • If the batteries should leak, carefully wipe the fluid out of the battery compartment, then insert new batteries. q Open the battery compartment cover on the back of the remote control unit. w Insert the two R6P (AA) batteries, following the + and - marks in the battery compartment. e Close the cover of the battery compartment. Using the Remote Control Unit Cautions on Use • The remote control unit may not operate if the remote • If the remote control unit is pointed away from the sensor is exposed to direct sunlight or the strong light remote sensor during continuous operations (such as from a lighting fixture, or if there is an obstacle when turning the volume up or down), the operation between the remote control unit and the remote will stop. If this happens, point the remote control unit sensor. at the remote sensor and press the button again. • Do not press buttons on the remote control unit and on the set at the same time. Doing so could result in malfunction. ˃ N ˃ B B TTUIMNEERD STEREO AUTO MHz CH • The remote sensor is located on the receiver. Point the remote control unit at the remote sensor as shown on the diagram when operating it. The remote control unit will operate from a direct distance of approximately 7 meters, but this distance will be shortened if obstacles are present or if operated at an angle. (The remote control unit will operate at an angle of up to 30° in either direction.) ENGLISH 9