Electrolux CEI30EF5GS Service Manual - Page 38

Halogen Oven Lights Each light assembly houses a replaceable 40 watt bulb behind the clear lens. To remove the lens use a thin bladed screwdriver or putty knife to gently pry the lens out. Take care not to damage the finish of the oven wall. (Photo A) Photo A With the lens removed the bulb can be accessed. Remove the bulb by pulling it out of the porcelain base in the direction shown by the arrow in photo B. Use only the correct replacement bulb. Please note: do not allow your fingers to touch the new bulb when replacing. This will shorten the life of the new bulb. Use a paper towel to cover the new bulbwhen installing. If the socket or harness are defective the complete assembly with attached harness, bulb and lens must be replaced. The light assembly is installed from the inside of the oven cavity. When removing the old assembly it is recommended to tie a string to the end of the harness plug as the assembly is being removed. This string can then be used to fish the wire harness of the replacement assembly through the oven cavity liner and inner shield. Always orient the assembly with the wire harness towards the center of the oven. (Photo C) Pull Bulb To Remove Toward Oven Center Photo C Photo B Page 38