Electrolux CEI30EF5GS Service Manual - Page 45

Replacing Warmer Drawer Element & Thermo Disc The warmer drawer element and thermo disc are mounted to a metal base pan which must be removed in order to replace the element. Remove the lower wire shield from rear of the range. Unplug the warmer drawer harness connector and push the connector through the slot in the back panel so that it can be removed with the element and base assembly. Remove the screws that secure the warmer drawer base and the warmer drawer side shields to the main back panel. (Photo A) Photo A Harness Connector Plug Side Shield Screws Element Base Pan Screw Remove the ¼" hex screws that secure the drawer guide rail and element base pan on each side of the drawer opening. (Photo B) Remove the drawer guide rail and drawer shield together by pulling straight forward. Guide Rail Screw Drawer Guide Rail Once both of the drawer guide rails and side shields have been removed the base pan and element assembly can be pulled forward to remove from the range. (Photo C) Photo B With the element and base pan assembly removed the element and thermo disc are accessible for servicing. (Photo D) To remove the element from the pan remove the screws and clips that secure it to the pan. Also remove the screw that secures the thermo disc mounting bracket. When reinstalling the thermo disc mounting bracket always insure that the element terminal shield is installed and properly positioned. Photo C Drawer Side Shield Base Pan Screw Pull base pan forward to remove →→ Photo D Mounting Screws and Clips Thermo Disc Mounting Bracket Warmer Drawer Element and Base Pan Assy Page 45 Terminal Shield