Home » Epson Manuals » Laptops » Epson ActionNote 4SLC/33 » Manual Viewer

Epson ActionNote 4SLC/33 User Manual - Page 142

Fax/modem, Command Set B-15, Fcc Compliance Statement For American Users

Get Epson ActionNote 4SLC/33 PDF manuals and user guides

View all Epson ActionNote 4SLC/33 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 142 highlights

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS Note FCC ID: JRUAM-3S25 This device complies with FCC Rules, Part 15. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help. WARNING The correction of a telephone company line to this equipment, other than the one supplied with the modem, will invalidate the FCC Certification of this device. It is the responsibility of the user to connect and use only the ferrite-loaded telephone company line supplied with this modem. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. Fax/Modem Command Set B-15

Section	Page
FRONT MATTER	1
CONTENTS	8
INTRODUCTION	13
Standard Configuration	13
Optional Equipment	15
Where to Get Help	15
How to Use this Manual	17
Conventions Used in This Manual	18
CHAP 1-SETTING UP THE COMPUTER	19
Unpacking the Computer	20
Identifying the System Parts	21
Front View	21
Rear Panel and Left Side	24
Connecting the AC Adapter	26
Opening the Screen	28
Turning On the Computer	29
CHAP 2-USING YOUR COMPUTER	32
Taking Care of the Computer	33
Copying the Reference Diskette Utilities	34
Using the Password Function	35
Typing the Password	35
Using the Keyboard	36
Special Keys	38
Using F11 and F12	39
Using the Embedded Numeric Keypad	40
Stopping a Command or Program	40
Resetting the Computer	41
Turning 0ff the Computer	42
Changing the CPU Speed	42
Using the LCD Screen	43
Using Diskettes	43
Inserting and Removing Diskettes	44
Write-protecting Diskettes	45
Making Backup Copies	46
Using a Single Diskette Drive System	46
Using a Hard Disk	47
Backing Up the Hard Disk	47
Saving Battery Power	48
Using Memory	48
CHAP 3-POWERING UP THE COMPUTER	51
Using the AC Adapter	51
Using the Battery Pack	52
Replacing the Battery Pack	52
Recharging the Battery	55
Low Battery Indicator	56
Using the Suspend/Resume Switch	57
Using Setup to Conserve Battery Power	58
CHAP 4-CONNECTING OPTIONAL DEVICES	59
Connecting an External Monitor	60
Connecting a Parallel Printer	62
Connecting a Serial Device	63
Checking the Serial Port Settings	65
Using the EXT KB Port	65
Connecting the Trackball	66
Connecting Any Other Pointing Device	67
Connecting an External Keyboard	67
Connecting the Internal Fax/Modem	67
Adding Memory Modules or a Numeric Coprocessor	69
Removing the Keyboard	69
Installing a Memory Module	71
Installing a Numeric Coprocessor	74
Replacing the Keyboard	76
CHAP 5-RUNNING SETUP	78
Starting the Setup Program	79
Changing the Settings	80
Automatically Configuring Your System	81
Saving Your Selections	81
Changing the Standard CMOS Setup	82
Changing the Advanced CMOS Setup	84
Changing the Advanced Chipset Setup	87
Changing the Password	89
Hard Disk Utility	90
Hard Disk Format	91
Auto Interleave	92
Media Analysis	92
CHAP 6-RUNNING SYSTEM DIAGNOSTICS	93
Starting the Program	94
Deleting Tests	95
Adding Tests	96
Running Tests	97
Resuming From an Error	98
System Diagnostic Tests	99
Error Messages	100
CHAP 7-USING THE VGA UTILITIES	103
Lotus 1-2-3, Version 2.x	105
Microsoft Windows, Version 3.0	106
WordPerfect, Version 5.1	107
Using the VGACONF Utility Program	108
Using VGACONF From the Command Line	111
APPENDIX A-TROUBLESHOOTING	114
Identifying Your System	115
Error Messages	116
The Computer Won’t Start	116
Battery Problems	117
AC Adapter Problems	118
The LCD Screen Is Blank	119
The External Monitor Screen is Blank	119
The Computer Locks Up	120
Password Problems	121
Diskette Problems	122
Diskette Drive Problems	123
Hard Disk Problems	123
Software Problems	124
Printer Problems	125
Memory Module Problems	126
Numeric Coprocessor Problems	126
CMOS Battery Problems	127
APPENDIX B-FAX/MODEM COMMAND SET	128
When to Issue Commands	128
AT Command Summary	129
Dial Modifiers	131
MNP Command Summary	132
AT Register Summary	135
Option Registers	136
MNP Register Summary	139
Result Code Summary	140
APPENDIX C-SPECIFICATIONS	143
Main Unit	143
Controllers	144
Keyboard	145
MassStorage	145
LCD Display	145
Power Supply	145
Physical Dimensions	146
Environmental Requirements	146
Power Source Requirements	147
GLOSSARY	148

Match case Limit results 1 per page

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS

Note

FCC ID: JRUAM-3S25

This device complies with FCC Rules, Part 15. Operation is subject to the following two

conditions

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause

undesired operation.

This equipment has been tested and found

comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio or

television reception. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected

Consult the dealer or an experienced radio/TV technician for help.

WARNING

The correction of a telephone company line to this equipment, other than the one supplied

with the modem, will invalidate the FCC Certification of this device. It is the responsibility

of the user to connect and use only the ferrite-loaded telephone company line supplied

with this modem.

Changes or modifications not expressly approved by the manufacturer could void the

user’s authority to operate this equipment.

Fax/Modem

Command Set B-15