Epson TM-H6000IV with Validation Technical Reference Guide - Page 101
Inserting Validation Paper (For Validation Models), touches the stopper.
![]() |
View all Epson TM-H6000IV with Validation manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Chapter 4 Handling Inserting Validation Paper (For Validation Models) Insert the validation paper in the same way as normal slip paper (See "Inserting Slip Paper" on page 99.) or follow the steps below. • Do not insert checks that have clips or staples. This may cause paper jams. • The paper must be flat, without curls, folds, or wrinkles. 1 Turn on the printer. 2 Insert the paper with the right paper edge against the right side of the paper guide at the printer top, and insert it as far as it will go. 3 Insert the paper straight down until the bottom edge of the paper 4 touches the stopper. 4 When the printer starts feeding the paper, release it immediately. 5 Pull the ejected paper straight up out of the printer. 101
![](/manual_guide/products/epson-tmh6000iv-validation-technical-reference-guide-53ccca5/101.png)
Chapter 4
Handling
101
4
Inserting Validation Paper (For Validation Models)
I
n
ser
t
t
he val
i
da
ti
o
n
paper
in
t
he same way as
n
ormal sl
i
p paper (See
"I
n
ser
ting
Sl
i
p Paper" o
n
pa
g
e 99
.) or follow
t
he s
t
eps below.
1
Turn on the printer.
2
Insert the paper with the right paper edge against the right side of the
paper guide at the printer top, and insert it as far as it will go.
3
Insert the paper straight down until the bottom edge of the paper
touches the stopper.
4
When the printer starts feeding the paper, release it immediately.
5
Pull the ejected paper straight up out of the printer.
•
Do not insert checks that have clips or staples. This may cause paper jams.
•
The paper must be flat, without curls, folds, or wrinkles.