Epson TM-H6000IV with Validation Technical Reference Guide - Page 71
Connecting the Cash Drawer, Connecting the Drawer Kick-out Cable
![]() |
View all Epson TM-H6000IV with Validation manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 2 Setup Connecting the Cash Drawer Use the cash drawer handled by EPSON or your dealer. Connecting the Drawer Kick-out Cable • Specifications of drawers differ depending on makers or models. When you use a drawer other than specified, make sure its specification meets the following WARNING conditions. Otherwise, devices may be damaged. ∗ The load, such as a drawer kick-out solenoid, must be connected between pins 4 and 2 or pins 4 and 5 of the drawer kick-out connector. ∗ When the drawer open/close signal is used, a switch must be provided between drawer kick-out connector pins 3 and 6. ∗ The resistance of the load, such as a drawer kick-out solenoid, must be 24 Ω or more or the input current must be 1A or less. ∗ Be sure to use the 24V power output on drawer kick-out connector pin 4 for driving the equipment. • Use a shield cable for the drawer connector cable. 2 • Two driver transistors cannot be energized simultaneously. • Leave intervals longer than 4 times the drawer driving pulse when sending it continuously. • Be sure to use the printer power supply (connector pin 4) for the drawer power source. • Do not insert a telephone line into the drawer kick-out connector. Doing so may damage the telephone line or printer. • Do not connect the USB connector ("B" Plugs of the series B connectors) to the drawer kick-out connector. Doing so may damage the printer or the host computer system. Connect the connector of the drawer kick-out cable to the printer. 71
![](/manual_guide/products/epson-tmh6000iv-validation-technical-reference-guide-53ccca5/71.png)