Epson TM-H6000IV with Validation Technical Reference Guide - Page 86
Starting the status print and test print on the roll paper, Close all covers and the receipt unit.
View all Epson TM-H6000IV with Validation manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Starting the status print and test print on the roll paper Follow the steps below to start a status print and test print on the roll paper. 1 Install the roll paper. 2 Close all covers and the receipt unit. 3 While pressing the Feed button, turn on the printer. (Keep pressing the button until the printer starts printing.) The printer starts printing the current status of the printer on the roll paper. With the Ethernet interface, before printing starts, it takes 6 seconds if the IP address is fixed and 13 seconds if the IP address is obtained with the automatic setting. (It may take longer, depending on the response time from the host.) When the printer finishes printing the printer status, the following message is printed and the Paper LED flashes. (The printer is now in the self-test wait mode.): "Select Modes by pressing Feed button. Continue SELF-TEST: Less than 1 second Mode Selection : 1 second or more" 4 To start the test print, press the Feed button (less than 1 second). The printer prints a rolling pattern on the roll paper, using only the built-in character set. If you select the mode selection, see "NV Graphics Print Mode" on page 90, "Receipt Enhancement Information Print Mode" on page 92, or "Memory Switch Setting Mode" on page 93. After printing the following message, the printer is initialized and returned to the normal mode. "*** completed***" 86