Fujitsu 4860C Operator's Guide - Page 167
Symptom2, the scanner. Pressing the power button more than 2 seconds will turn off the power.
View all Fujitsu 4860C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
SOLVING COMMON PROBLEMS Symptom2 The operator panel LCD goes out. Has it been a while since you turned on the scanner ? (15 to 60 minutes) YES NO NO Does the LCD remain blank even after the scanner has been turned on again? Scanner is in Power save mode. Press any button (except Power button) on the operator panel to wake it up. The scanner operation is normal. YES Contact an authorized FUJITSU Scanner service provider. 5 (* ) Press any button except Power button. The Power button will not work to wake up the scanner. Pressing the power button more than 2 seconds will turn off the power. 5.2 Troubleshooting 5-9
5-9
5.2 Troubleshooting
5
SOLVING COMMON PROBLEMS
(* ) Press any button except Power button. The Power button will not work to wake up
the scanner. Pressing the power button more than 2 seconds will turn off the power.
YES
NO
YES
Has it been a while since you turned
on the scanner ? (15 to 60 minutes)
Does the LCD remain blank even after
the scanner has been turned on again?
Scanner is in Power save
mode. Press any button (except
Power button) on the operator
panel to wake it up.
The scanner operation is
normal.
Contact an authorized FUJITSU
Scanner service provider.
Symptom2
The operator panel LCD goes out.
NO