Fujitsu 4860C Operator's Guide - Page 253

24. Selection of Imprinter In this scanner, you can install the Pre- and Post-imprinters (optional accessories). However, you cannot use both imprinters simultaneously. The following procedure describes how to select the imprinter you want to use. 1) Press (Next button) or (Previous button), and display the on the LCD panel. ! 24 I mp r i n t e r 7 Se l e c t Pr e/ Po s t 2) At , press (Left arrow button) or select the imprinter you want to use. (Right arrow button) and The blinking item is the one selected. HINT When "Pre" is blinking: the Pre-imprinter (fi-486PRFR) is selected When "Post" is blinking: the Post-imprinter (fi-486PRRE) is selected. OPERATOR PANEL MENUS 3) Press (Enter button) to confirm the setting. Then configure the priority setting. The is displayed. If "Pre" is selected at : ! 24- 1 Pr i o r i t y =I / F / Pan e l : Pr e If "Post" is selected at : ! 24- 1 Pr i o r i =I / F / Pan e l : ty Po s t The imprinter selection can be specified from the interface or the operator panel. The priority setting is to decide which setting the scanner must follow; the setting done on the interface or the operator panel 7.3 Setup Mode Details 7-53