Fujitsu 4860C Operator's Guide - Page 297
Detection by Document Overlapping and Length, Thickness and Length
View all Fujitsu 4860C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 297 highlights
- Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line of the document. - The deviation in the amount of the light transmitted through background areas must not be less than 10%. Detection by Document Overlapping and Length Sheets of the same thickness and length shall be set in the ADF at a time. - Paper weight: 52 g/m2 - 127 g/m2 or 14 lbs to 34 lbs - Document length deviation: 1% or less - Printed area: 12% or less - No black printed areas are allowed at the center area (26 x 10mm or 1 x 0.4 inch) at the leading edge of the document. - Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line of the document. - The deviation in the amount of the light transmitted through background areas must not be less than 10%. Detection by Document Thickness and Length Sheets of the same thickness and length shall be set in the ADF at a time. - Paper weight: 52 g/m2 - 127 g/m2 or 14 lbs to 34 lbs - Document length deviation: 1% or less - Printed area: 12% or less - No black printed areas are allowed at the center area (26 x 10mm or 1 x 0.4 inch) at the leading edge of the document. - Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line of the document. - The deviation in the amount of the light transmitted through background areas must not be less than 10%. Detection by Document Overlapping, Thickness and Length Sheets of the same thickness and length shall be set in the ADF at a time. - Paper weight: 52 g/m2 - 127 g/m2 or 14 lbs to 34 lbs - Document length deviation: 1% or less - Printed area: 12% or less - No black printed areas are allowed at the center area (26 x 10mm or 1 x 0.4 inch) at the leading edge of the document. - Punched holes are not allowed within 35mm (1.4 inch) of the vertical center line of the document. ●AP-3