Fujitsu 4860C Operator's Guide - Page 182
Document Quality, 6For the replacement and re-installation of Pick roller unit and Brake roller unit
View all Fujitsu 4860C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Continued from the previous page Are the Pick roller, the Brake roller YES Clean the dirty parts. (* 5) and the Pinch rollers dirty? NO NO Are the Pick roller unit and the Brake roller unit installed properly? Install the Pick roller and the Brake roller properly. (* 6) YES YES How many sheets have you scanned? Check consumables life to ensure you have not scanned more than 300,000 pages. (* 7) Replace the Pick roller unit and the Brake roller unit if necessary. (*6) NO Contact an authorized FUJITSU Scanner service provider. (* 1) For the details on required conditions, refer to the section "6.2 Document Quality" on page 6-3. (* 2) For the details on how to set up the Paper Length, refer to "7.3 Setup Mode Details", "10. Setting Short document scan mode (Paper Length setup)" on page 7-36. (* 3) For the details on how to clean ADF, refer to "Chapter 3 DAILY CARE" on page 3-1. (* 4) For the details on how to replace Pas ASSY, refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1. (* 5) For the details on scanner cleaning, refer to "Chapter 3 DAILY CARE" on page 3-1. (* 6) For the replacement and re-installation of Pick roller unit and Brake roller unit, please refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1. (* 7) Check the consumable wear. For the method to check the number of sheets scanned for each consumable, refer to "7.3 Setup Mode Details", "9. Abrasion counter reset" on page 7-33. 5-24 5.2 Troubleshooting