Fujitsu 4860C Operator's Guide - Page 33
Lifting or lowering the hopper, 3 Basic Operations of the Operator Panel
View all Fujitsu 4860C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
■ Lifting or lowering the hopper When the scanner has no errors (Check LED is not lit), the Hopper height position can be changed. CAUTION During hopper height adjustment, do not put your hands or anything on or under the hopper to prevent your fingers from getting caught and injured. If something is caught in the mechanism, the scanner may be damaged. 1 The Hopper height adjustment function is not available when: - The "Read" LED is lit - A scanning operation is in progress - The scanner is in test mode (excluding Single feed and Multi-feed) - The scanner is in setup mode (1) In normal mode (i.e. not in test mode nor in setup mode), the Hopper height changes as follows by pressing (Exit button) for more than two seconds: BASIC SCANNER OPERATIONS 1. When the Hopper is at the bottom position, it moves up to 250 sheet position. 2. When the Hopper is at 250 sheet position, it moves down to the bottom position. 3. When the Hopper is at the highest position, it moves back to where it was when the scan operation started. The Hopper is positioned at the bottom when the power is turned on. HINT 1.3 Basic Operations of the Operator Panel 1-7