Fujitsu 4860C Operator's Guide - Page 257
immediately to the vlaue specified in 4., At <Screen25-4>
View all Fujitsu 4860C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
OPERATOR PANEL MENUS 5) At , you can specify if the numbering should be initialized to the specified initial value in 4) at hopper empty. To specify to initialize the numbering counter at hopper empty, press (Left arrow button) and select [On]. Press (Enter button) to confirm the selection. Then, is displayed. To specify not to initialize the counter at hopper empty but continue incrementing, select [Off], press (Enter button) and then 7 is displayed. ! 25- 4 = Re s e t No w No / Ye s 6) At , specify if the numbering counter should be initialized immediately to the vlaue specified in 4). To specify to initialize immediately, press (Right arrow button) and select [Yes]. To specify not to initialize immediately, select [No] and press button). (Enter 7) Press Press (Enter button) to confirm the setting. (Exit button), and the LCD display goes back to [Ready] screen. ATTENTION Command from the PC takes the priority over the setting from the Operator panel. 7.3 Setup Mode Details 7-57