Fujitsu 4860C Operator's Guide - Page 180

Continued from the previous page Are the Pick roller unit and the NO Brake roller unit installed properly? nstall the Pick roller and the Brake roller properly. (* 6) YES Have you scanned many sheets? Check the consumables life to ensure you have not scanned more than 300,000 sheets. (* 7) YES NO Contact an authorized FUJITSU Scanner service provider. Replace the Pick roller unit and the Brake roller unit if necessary. (*6) (* 1) For the details on required conditions, refer to the section "6.2 Document Quality" on page 6-3. (* 2) For the double-feed detection conditions, refer to "APPENDIX 2 DOUBLE- FEED (MULTI-FEED) DETECTION CONDITIONS" on page AP-2. (* 3), (* 5) For the details on how to clean scanner, refer to "Chapter 3 DAILY CARE" on page 3-1. (* 4) For the details on how to replace Pas ASSY, refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1. (* 6) For the details on how to replace and install Pick roller unit and Brake roller unit, refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1. (* 7) Check the wear of rollers. For the method to check the number of sheets scanned for each consumable, refer to "7.3 Setup Mode Details", "9. Abrasion counter reset" on page 7-33. 5-22 5.2 Troubleshooting