Fujitsu 4860C Operator's Guide - Page 254
Panel: Pre or Panel: Post blinks and, the scanner forcibly follows the settings
View all Fujitsu 4860C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
4) At , press (Left arrow button) or (right arrow button), and select the setting you want to give priority. Pressing (Left arrow button): "I/F" blinks and the scanner forcibly follows the settings done on the interface. Pressing (Right arrow button): "Panel: Pre" or "Panel: Post" blinks and the scanner forcibly follows the settings done on the operator panel. Press Press screen. (Enter button) to confirm the setting. (Exit button) and the LCD display goes back to the [Ready] ATTENTION This screen is displayed only when both imprinters (fi-486PRFR and fi-486PRRE) are installed. 7-54 7.3 Setup Mode Details
7-54
7.3 Setup Mode Details
4) At <Screen24-1>, press
(Left arrow button) or
(right arrow button), and
select the setting you want to give priority.
Press
(Enter button) to confirm the setting.
Press
(Exit button) and the LCD display goes back to the [Ready]
screen.
Pressing
(Left arrow button):
“I/F” blinks and the scanner forcibly
follows the settings done on the
interface.
Pressing
(Right arrow button):
“Panel: Pre” or “Panel: Post” blinks and
the scanner forcibly follows the settings
done on the operator panel.
ATTENTION
This screen is displayed only when both imprinters (fi-486PRFR and
fi-486PRRE) are installed.