Garmin G1000H Bell 407GX Cockpit Reference Guide - Page 44

Flight Planning Flight Instruments EICAS Nav/Com/ XPDR/Audio AFCS GPS Nav Flight Planning Procedures 4) For Direct-to planning: a) Press the WPTS Softkey and verify that the starting waypoint field indicates 'P.POS' (present position). b) If necessary, press the MENU Key and select 'Set WPT to Present Position' to display 'P.POS'. c) Press the ENT Key and the flashing cursor moves to the ending waypoint field. d) Enter the identifier of the ending waypoint and press the ENT Key to accept the waypoint. Or: For point-to-point planning: a) Enter the identifier of the starting waypoint. b) Once the waypoint's identifier is entered, press the ENT Key to accept the waypoint. The flashing cursor moves to the ending waypoint. c) Again, enter the identifier of the ending waypoint. d) Press the ENT Key to accept the waypoint. Or: For flight plan leg planning: a) Press the FPL Softkey (at the bottom of the display). b) Turn the small FMS Knob to select the desired flight plan (already stored in memory), by number. c) Turn the large FMS Knob to highlight the 'LEG' field. d) Turn the small FMS Knob to select the desired leg of the flight plan, or select 'CUM' to apply trip planning calculations to the entire flight plan. Selecting 'FPL 00' displays the active flight plan. If an active flight plan is selected, 'REM' is an available option to display planning data for the remainder of the flight plan. NOTE: The page mode must be set to 'MANUAL' to perform the following steps. 5) Turn the large FMS Knob to highlight the departure time (DEP TIME) field. NOTE: The departure time on the Trip Planning Page is used for preflight planning. Refer to the Utility Page for the actual flight departure time. Hazard Avoidance Additional Features Abnormal Operation Annun/ Alerts Appendix Index 28 Garmin G1000H™ Cockpit Reference Guide for the Bell 407GX 190-01254-00 Rev. A