Gateway 7400 System Manual (PDF Version) - Page 46
Replacing a hot-plug drive
![]() |
View all Gateway 7400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Replacing a hot-plug drive The hot-plug drives are located at the bottom of the front panel. The hot-plug bay supports as many as six 1-inch high 3.5-inch SCA-II SCSI hard drives. The hot-plug drives are assigned SCSI ID numbers by the hot-plug backplane with the drive at the far left side of the hot-plug bay assigned SCSI ID 0. The backplane assigns SCSI IDs to the other drives in order up to SCSI ID 5 at the far right side of the hot-plug bay. Important Gateway tests and verifies the operation and compatibility of the drives it sells. Especially in a hot-plug or mission-critical environment, additional or replacement drives must conform to Gateway standards. SCSI ID 0 SCSI ID 1 SCSI ID 2 SCSI ID 3 SCSI ID 4 SCSI ID 5 Install the drive in the left-most drive bay first and in increasing order by SCSI ID number thereafter. 38 Replacing and Adding System Components
![](/manual_guide/products/gateway-computers-7400-manual-pdf-version-59f0f05/46.png)