Gateway 7400 System Manual (PDF Version) - Page 65
To remove the processor, To install the new processor, Gently place the new processor into the socket.
View all Gateway 7400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
To remove the processor: 1 Open the locking lever on the processor socket by moving the lever slightly out to the side and then lifting it up 90 degrees. Locking lever 2 Lift the old processor straight up and out of the socket. To install the new processor: 1 Hold the new processor over the empty processor socket and verify that pin 1 on both the processor and the socket are aligned. Pin 1 is near the marked corner. 2 Gently place the new processor into the socket. Pin 1 Processor 3 Secure the processor by lowering the locking lever until the lever latches into place. The processor will slip into place without pressure when aligned correctly. Replacing or adding a processor 57
Replacing or adding a processor
57
To remove the processor:
1
Open the locking lever on the processor socket by moving the lever
slightly out to the side and then lifting it up 90 degrees.
2
Lift the old processor straight up and out of the socket.
To install the new processor:
1
Hold the new processor over the empty processor socket and verify that
pin 1 on both the processor and the socket are aligned. Pin 1 is near the
marked corner.
2
Gently place the new processor into the socket.
3
Secure the processor by lowering the locking lever until the lever latches
into place. The processor will slip into place without pressure when
aligned correctly.
Locking
lever
Pin 1
Processor