Gateway 7400 System Manual (PDF Version) - Page 74
Once the card is securely placed, slide the card guide release tab down
![]() |
View all Gateway 7400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
8 Press the card guide release tab upward to release the cards and allow the new card to be inserted into the card guide (for full-length expansion cards). Important The card guide release tab is held in place during shipping by a cotter pin. Remove the cotter pin before moving the release tab. You can replace the cotter pin or leave it out. 9 Insert the bottom edge of the expansion card (the keyed edge with the contacts) into the slot on the system board and push in firmly to seat the card. Expansion card retention clip Card guide release tab 10 Once the card is securely placed, slide the card guide release tab down again (for full-length expansion cards) and press the expansion card retention clip through the back panel until it clicks into place to secure the card. 11 Connect any cables to the card (see card documentation for proper cable orientation). 66 Replacing and Adding System Components
![](/manual_guide/products/gateway-computers-7400-manual-pdf-version-59f0f05/74.png)