Harman Kardon AVR 1700 Quick Start Guide - Page 8

AVR Connections 5. Use the remote's arrow and OK buttons to select "EzSet/EQ." EzSet/EQ Place microphone at listening position and plug into Headphone Jack. Do you want to start EzSet/EQ? Yes No 6. Select "Yes." The Speaker Configuration menu wlll appear. EzSet/EQ Speaker configuration. 5.1 Cancel 7. Select "5.1." 8. Remain silent while the test noise plays through your system's speakers. When the calibration has completed, press the OSD button to exit. Assign the AVR Input Connections 1. Review the input connections you listed on the connection table, on page 4. Note what changes (if any) you have made from the default AVR Input Connector assignments that appear on the list. If you connected your source devices according to the entries in the "Default AVR Input Connector" column of the table on page 4, you can skip this section. 2. Turn on your TV and select the TV input where you connected the AVR in Connect Your TV, on page 3. 3. Press the remote control's OSD button. The AVR's on-screen display (OSD) setup menu will appear on the TV. (Note: If you have used a composite video connection to your TV, the OSD menus will not appear on your TV. Follow the steps below using the AVR's front-panel display.) MASTER MENU Source Select Source Setup Surround Mode EzSet/EQ Manual Setup Network System Setup 4. Use the remote's arrow and OK buttons to select "Source Setup." If there is a Source Selector for which you want to assign different video or audio connections. use the left/right arrow buttons to select it, and press the OK button. Source Setup Source Title Video In Audio In Tone Bass Treble Night Mode Record Out < Cable/Satellite > HDMI 1 HDMI 1 Out 0 0 Off Analog 5. Select "Video In" and use the left/right arrow buttons to select the video input connector you want to assign to the Source Selector button. Press the OK button. (Note: If you select an HDMI connector for the Video connection the Audio connection will automatically change to the same HDMI connector.) Source Setup Source Title Video In Audio In Tone Bass Treble Night Mode Record Out < Cable/Satellite > HDMI 2 HDMI 2 Out 0 0 Off Analog 6. Select "Audio In" and use the left/right arrow buttons to select the audio input connector you want to assign to the Source button. (Note: If you have assigned an HDMI Video connector for the Source button you cannot assign a different Audio connector.) Source Setup Source Title Video In Audio In Tone Bass Treble Night Mode Record Out < Cable/Satellite > Composite 1 Optical 1 Out 0 0 Off Analog 7. Repeat steps 4 - 6 for the remaining audio/video connections that you want to re-assign. You are now ready to enjoy your AVR! IMPORTANT: For complete set up information, and for complete information about using all of your audio/video receiver's features and capabilities, download the AVR 1700, AVR 170, AVR 170/230C Owner's Manual from www.harmankardon.com. 8