Hayward Variable Speed Pump Technical Guide - Page 50

Code/Fault - problems

Get Hayward Variable Speed Pump PDF manuals and user guides View all Hayward Variable Speed Pump manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

Troubleshooting/Fault Codes Code/Fault Indications The freeze protection in the EcoStar does not work properly. The freeze protection is actually for protection of the EcoStar drive. It will not and should not be expected to protect any plumbing or other equipment from freezing temperatures. (page 23) My EcoStar is connected and operating via the GL/Hayward control. The Speed buttons and Quick Clean buttons on the pump interface do not work. This is correct. When the control is operating the EcoStar, the Speed buttons and the Quick Clean button is inactive. Only the Stop/Resume and Menu button is active. The EcoStar is experiencing interference with an X-10 home automation control and is causing other devices to come on and off. Try changing channel on X-10. If problem persists, purchase (2) model XPF 20A 3-wire noise filters through X-10 website. The EcoStar is wired and set to operate via the GL/Hayward control. When a command is sent to the pump, the EcoStar interface reads "Remote Stop Engaged". This indicates that the comm. wires from the control are connected in the EcoStar to the input terminals for relay control. Remove wires and connect to the comm. bus plug on the drive (page 10). Page 48

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Troubleshooting/Fault Codes
Code/Fault
Indications
The freeze protection in the EcoStar
does not work properly.
The freeze protection is actually for protection of
the EcoStar drive.
It will not and should not be
expected to protect any plumbing or other
equipment from freezing temperatures. (page 23)
My EcoStar is connected and operating
via the GL/Hayward control. The Speed
buttons and Quick Clean buttons on
the pump interface do not work.
This is correct. When the control is operating the
EcoStar, the Speed buttons and the Quick Clean
button is inactive. Only the Stop/Resume and
Menu button is active.
The EcoStar is experiencing
interference with an X-10 home
automation control and is causing
other devices to come on and off.
Try changing channel on X-10. If problem persists,
purchase (2) model XPF 20A 3-wire noise filters
through X-10 website.
The EcoStar is wired and set to operate
via the GL/Hayward control. When a
command is sent to the pump, the
EcoStar interface reads “Remote Stop
Engaged”.
This indicates that the comm. wires from the
control are connected in the EcoStar to the input
terminals for relay control. Remove wires and
connect to the comm. bus plug on the drive (page
10).
Page 48