HP Color LaserJet 8500 Service Manual - Page 403

Table 42. Unnumbered printer messages (continued) INSTALL IMAGING DRUM OPEN FRONT DOOR Description: The printer has detected that the imaging drum is not installed. Note: All doors must be closed for the printer to detect the imaging drum. Event log message: None Action: 1 Install the imaging drum before attempting to print. If the condition persists, take the imaging drum out and reinstall it. Note: The imaging drum must be installed and the upper lever must be to the left in order for the carousel to rotate. 2 Turn the printer off and on to reset the printer. 3 Replace the drum cartridge. 4 Replace the drum cartridge if the drum cartridge on/off switch guide is deformed. 5 Make sure that the drum cartridge is installed. • Install the drum cartridge if it is not installed. • If the drum cartridge is already installed, turn the printer off, reinstall the drum cartridge, and turn the printer on again. 6 Reconnect connectors J641 to J643 and J647 on the main relay PCA, connectors J671 and J673 on the subrelay PCA, connector J102 on the power supply, and connector J227 on the controller board. 7 Check electrical continuity between connector J641-1 (+24 VB) and J642-3 (PMP) on the main relay PCA when the door switch (SW641) is turned on. If there is no electrical continuity, replace the right cover switch on the main relay PCA. 8 Check electrical continuity between connector J671-2 (PMP) and J671-2 (PFUPR) on the subrelay PCA when the door switch (SW671) is turned on. If there is no electrical continuity, replace the delivery cover/front cover switches on the subrelay PCA. 9 Measure the voltage across connector J641-1 (+24 VB) and J641-A1 (GND) on the main relay PCA after the printer is turned on. If the voltage is not 24 V, replace the power supply. 10 Measure the voltage across connector J647B11 (+24UH) and J647-4 (GND) on the main relay PCA after the printer is turned on. If the voltage is not 24 V, replace the main relay PCA. EN Printer message troubleshooting 401