HP Color LaserJet 8500 Service Manual - Page 48

Safety information Note FCC regulations This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the U.S. Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase separation between equipment and receiver.
Connect equipment to an outlet on a circuit different from that on which the receiver is located.
Consult your dealer or an experienced radio/television technician. Any changes or modifications to the printer not expressly approved by HP could void the user's authority to operate this equipment. Use of a shielded interface cable is required to comply with the FCC rules. Canadian DOC regulations Complies with Canadian EMC Class B requirements. «Conforme á la classe B des normes canadiennes de compatibilité électromagnétiques. «CEM».» 46 Chapter 1 - Product information EN