HP D2D110 HP StorageWorks D2D Backup System User Guide (EH880-90950, October 2 - Page 53
LEDs, Understanding the LEDs, Bootup LED sequence, Firmware LED sequence, Beacon mode
View all HP D2D110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
6 LEDs In this chapter: • "Understanding the LEDs" on page 53 • "Beacon mode" on page 53 Understanding the LEDs Figure 28 LEDs 1 Disk Activity 2 Disk Status 3 Disk Capacity 4 Status 5 Network 6 Power Flashing Green = Disk activity in progress. Solid Green = All disks are working correctly. Flashing Orange = A disk has failed. Solid Green = Normal operation and disk space is available. Solid Orange = Disk threshold capacity exceeded, device is nearly full. Solid Green = System is booted and operating normally. Flashing Green = System is powering up or shutting down. Flashing Orange = System has failed. Off = No network connection or network not configured. Solid Green = A Gigabit Ethernet connection is made. Solid Orange = A 10/100Base-T connection is made. Solid Green = Power on. Bootup LED sequence During power on, the LEDs will perform a self-test sequence. All LEDs with the exception of the status LED will then be extinguished until the boot sequence is completed. Firmware LED sequence During a firmware upgrade, all LEDs apart from the Power LED flash with an alternate green and orange. Beacon mode The HP D2D Backup System also supports a Beacon LED sequence, which helps a user identify which unit is being configured, if several are connected to the network. D2D Backup System 53